Loading...

With this calculator you can determine the correct spacing between supports using the criteria of maximum permissible pipe deflection or sag and allowable bending stress due to dead weight loads. The calculator also allows you to place a concentrated load such as valve or flange assembly at the center of the span. Selecting the correct pipe support span is an important aspect of piping design. The calculator gives a PASS output if both allowable deflection (sag) in the pipe and the maximum bending stress are within the permissible limits else it will give you a FAIL output. You can avoid excessive bending stresses and pipe sags from the uniform and concentrated loads between the supports using this calculator.  

Pipe Deflection and Bending Stress due to Support Span for Steel Piping

Input the values below to calculate the pipe support span. Fields with * cannot be left blank.

🔧

Pipe Deflection and Bending Stress Calculator

Calculate deflection, bending stress, and moment for steel piping systems

Pipe Size Selection

Select the nominal pipe size
Select the wall thickness
--
--

Pipe Properties and Uniformly Distributed Loads

psi
Use 5000 psi for CS pipes up to 400°F (limit the longitudinal stress due to deadweight effect to Sh/4)
ksi
Use 27,700 ksi (= 27.7 × 10⁶ psi) for CS pipes up to 400°F
kg/m³
Use 1000 kg/m³ for water
kg/m³
Use 150 kg/m³ for Rockwool
mm
Enter 0 if no insulation
kg/m
Additional loads per unit length if applicable

Support Span and Concentrated Load

m
Distance between pipe supports in meters
kg
Mass of component (e.g., valve, flange assembly) at center of span

Deflection Limits

mm
Typical value is 6.35 mm (1/4 inch) or L/300